Eminent EM8622 Bedienungsanleitung PDF herunterladen (Seite 5)

ENGLISH

1) Remove the screw and open the case

2) Install the batteries according to the positive and negative signs (Remove the

insulating strip before the first use)

3) Mount the backcover on the door frame or wall

4) Close the case and replace the screw

Note : Opening the cover will trigger the tamper switch ! You can disarm it by entering

the admin code 123456 followed by [#].

Note : The default admin code is : 123456. See chapter “Change Admin Code” to

change it.

Note : The default user code is : 1234. See chapter “Change User Code” to change it.

3.0 Usage

The control panel can be used as a remote control. User code or admin code should

be input before the operation of Arm, Disarm, Home Mode and Mute Mode.

3.1 Arm the alarm system

Input user code or admin code, and press [Arm] key. The LED indicator

flashes once and the control panel beeps once and sends Arm command to

the alarm system.

When the alarm panel receives the signal, the siren will beep once and the

Arm indicator will light on. The alarm system enters armed state.

1 2 3 4 5 6 7 8 9 10 ... 22 23

Keine Kommentare

Eminent EM8622 Bedienungsanleitung Seite 5